HVAC Service Professionals

While most maintenance contracts include a filter change and a sales pitch that is not the case with us. For both our clients and our ability to sleep at night every maintenance visit will make sure that your equipment is operating safely and efficiently with real data to back that up. As time goes on data points across all visits can help identify potential issues before they occur, and help prevent any downtime.

When equipment goes down being prepared to repair quickly is paramount. We have a large inventory of cookie cutter parts and more specific as well. In a large amount of cases the opportunity to increase unit efficiency is present and rarely taken by other outfits. In one prime example, circulator pumps on a boiler are typically inefficient brushed motors. Upgrading to an ECM pump will carry roughly a 50% increase on material cost ($50-$300 depending on size), however these upgrades can pay for themselves within a year on your utility bills. Delta T variable circulator pumps will also reduce the running time of your boiler and allow rooms of your home to maintain a more accurate temperature increasing savings and comfort. There are countless examples of parts that have similar effects that grant the same results.

With over a decade of experience on geothermal and heat pump systems we can help keep your equipment running or get it back into service properly. Green equipment typically has a lot more technology built inside and without relevant experience this can lead to net losses over standard equipment and expensive breakdowns with extensive downtime. Being familiar with the nuances this equipment brings is essential for efficient performance with extended lifespan. And with items like Heat Pump Water Heaters, we can help fill out your PSEGLI rebate and IRS form which in 2022 grant you a $600 & $150 credit respectively.

New installations should almost always be a last resort. If the reason is to help do your part for the environment, a lot of times the manufacturing toll is worse than the energy saved. However there is always a point where replacement of equipment is necessary. When this happens we can help facilitate this work as painless as possible. While we will subcontract this work, we will also be onsite verifying that installation meets our standards. With our choice of equipment instead of whatever is easy and cheap to obtain and our boots onsite all work will be done to the highest of standards. You would pay our subcontractors directly and our fee will be minimal. Typical markups in the industry for this will be anywhere from 25-50%. Ours will be a flat 10%. Being our discounts from repeated work this will typically be cheaper than dealing directly with our subcontractors anyway.